This is the initial check when connecting and setting up U-WAVE to a computer.
Follow the steps below.
(1). Please check the contents of the package.
1. U-WAVE-R main unit
2. Accessories
・CD-ROM
* The following data is stored in the CD-ROM.
- U-WAVEPAK program - USB driver / virtual COM port driver - U-WAVEPAK User's Manual (PDF version)
・USB cable
・Mounting plate, pan P tight screw with cross hole
* It is used when attaching the main unit to a wall.
・Others (U-WAVE-R User's Manual, Setup Manual, Warranty Card)
(2). In order to use it, you need to install the software.
≪ Step (1) You need to log in to your PC with ≫ and administrator privileges.
* The newly purchased accessories (current version) are compatible with Windows 2000 ~ Windows 10.
* It may not be supported when installing software (old version) that has already been installed on a new PC (Windows 10).
≪ Install the following three points on the CD-ROM that comes with step 2) ≫.
"U-WAVEPAK Program"
"USB Driver"
"Virtual COM Port Driver"
* Please refer to "2.1 Installing Programs and Device Drivers" (pages 2-1~2-16) in the "User's Manual (PDF version)".
* You can also refer to the included "Setup Manual (99MAL118B)". The "Setup Manual" can also be downloaded from our website.
* If another application (made by our company or another company) is launched, it may not be possible to operate normally.
(3). When the installation is complete, the LED lamp (green) of the U-WAVE-R connected to the PC will light up.